Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Section 1079 (Sunroof System)
WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Sunroof
- Component Parts and Harness Connector Location
- System Description
- CAN Communication System Description
- Wiring Diagram - SROOF -
- Terminals and Reference Value for BCM
- Terminals and Reference Value for Sunroof Motor
- Work Flow
- CONSULT-II Function
- Data Monitor
- Active Test
- Work Support
- Trouble Diagnosis Chart by Symptom
- BCM Power Supply and Ground Circuit Check
- Sunroof Switch System Check
- Sunroof Motor Assembly Power Supply and Ground Circuit Check
- Door Switch Check
- Fitting Adjustment
- Removal and Installation
- Sunroof Unit
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.