2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Consult-II Basic Operation Procedure

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. With ignition switch OFF, connect CONSULT-II to data link connector on vehicle, and turn ON ignition switch.
  2. Touch "START".
    Fig 1: Connecting Consult-II To Data Link Connector
    G00866962Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Touch "BCM" on "SELECT SYSTEM" screen.
    Fig 2: Touch "BCM" on "Select System" Screen Display
    G00866963Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Select item to be diagnosed on "SELECT TEST ITEM" screen.
Fig 3: "Select Test Item" Screen Display
G00866964Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.