2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK GROUND CONNECTIONS 
    1. Turn ignition switch OFF.
    2. Loosen and retighten ground three screws on the body. Refer to GROUND INSPECTION  .
      Fig 1: Checking Ground Connections
      G00775552Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    1. OK: GO TO 2.
    2. NG: Repair or replace ground connections.
  2. CHECK ENGINE COOLANT TEMPERATURE SENSOR 

    Refer to COMPONENT INSPECTION  .

    OK or NG 

    1. OK: GO TO 3.
    2. NG: Replace engine coolant temperature sensor.
  3. CHECK THERMOSTAT OPERATION 

    When the engine is cold [lower than 70°C (158°F)] condition, grasp lower radiator hose and confirm the engine coolant does not flow.

    OK or NG 

    1. OK: GO TO 4.
    2. NG: Repair or replace thermostat. Refer to THERMOSTAT AND THERMOSTAT HOUSING .
  4. CHECK INTERMITTENT INCIDENT 

    Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT  .

    Refer to WIRING DIAGRAM  .

    1. INSPECTION END 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.