Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
WARNING DOOR OPEN Screen is Not Shown
WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK VEHICLE SPEED SIGNAL
- Check vehicle speed signal. Refer to "VEHICLE SPEED SIGNAL CHECK FOR DISPLAY CONTROL UNIT ".
OK or NG
- OK : GO TO 2.
- NG : Check the malfunctioning parts.
- CHECK CAN COMMUNICATION LINE
- Check CAN communication line. Refer to "CAN COMMUNICATION LINE CHECK ".
OK or NG
- OK : GO TO 3.
- NG : After filling out CAN DIAG SUPPORT MONITOR check sheet, GO TO PRECAUTIONS WHEN USING CONSULT-II .
- CHECK COMMUNICATION LINE
- Check display communication line. Refer to "DISPLAY COMMUNICATION LINE CHECK (BETWEEN DISPLAY CONTROL UNIT AND DISPLAY) ".
OK or NG
- OK : Replace display.
- NG : Check the malfunctioning parts.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.