2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

RGB Screen Is Rolling (Excepting NAVI Screen)

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK HARNESS 
    1. Turn ignition switch OFF.
    2. Disconnect display control unit connector and display connector.
    3. Check continuity between display control unit and display.
      HARNESS CHECK CHART (1 OF 2)

      Terminals Continuity
      Display control unit (+) Display (-)
      Connector Terminal (Wire color) Connector Terminal (Wire color)
      M43 56 (G) M38 19 (G) Yes
    4. Check continuity between display control unit and ground.
    HARNESS CHECK CHART (2 OF 2)

    Terminals Continuity
    Display control unit (+) (-)
    Connector Terminal (Wire color)
    M62 56 (G) Ground No

    OK or NG

    1. OK : GO TO 2.
    2. NG : Repair harness or connector.
    Fig 1: Checking Continuity Between Display Control Unit And Display, And Between Display Control Unit And Ground
    G03360137Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK RGB SYNCHRONIZING SIGNAL 
    1. Connect display control unit connector and display connector.
    2. Turn ignition switch ON.
    3. Check signal between display connector M38 terminals 19 (G) and 21 with CONSULT-II or oscilloscope.
      1. 19 (G) - 21  : Refer to "TERMINALS AND REFERENCE VALUE FOR DISPLAY  ".

    OK or NG

    1. OK : Replace display.
    2. NG : Replace display control unit.
    Fig 2: Checking Voltage Between Display Connector M38 Terminals 19 And 21
    G03360138Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.