Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Shut Off Delay
When ignition switch is in the state of ON or ACC and a lighting switch is an AUTO position, after OFF and a door switch (a driver, passenger) serve as ON from the state of ON of headlamp in an ignition switch, a headlamp is turned on for 5 minutes, and headlamp, parking lamp, and fog lamp are set OFF after that.
When a door switch (a driver, passenger) is turned on from OFF during 45 seconds or a 5 minute timer operation, the present timer stops, newly turns on a headlamp for 5 minutes, and sets headlamp, parking lamp, and fog lamp to OFF after that.
When a door switch (a driver, passenger) is turned off from ON during 45 seconds or a 5 minute timer operation, the present timer stops, newly turns on a headlamp for 45 seconds, and sets a headlamp, parking lamp, and fog lamp to OFF after that.
When an ignition switch is turned off from ON during the above mentioned timer operation, the function, which stopped the timer and followed each lighting switch, is performed.
Shut off delay control mode can be changed by the function setting of CONSULT-II.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.