2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Front Power Window Regulator (Passenger Side) Circuit Check

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) OUTPUT SIGNAL 
    1. Turn igniting switch ON.
    2. Check voltage between front power window switch (passenger side) connector D35 terminals 8 and 9.
    CONNECTOR TERMINAL VOLTAGE CHART

    Connector Terminals (Wire color) Condition Voltage (V) (Approx.)
    (+) (-)
    D35 8 (L) Ground Closing Battery voltage
    Opening 0
    9 (G) Closing 0
    Opening Battery voltage

    OK or NG

    1. OK : GO TO 2.
    2. NG : Replace front power window switch (passenger side).
    Fig 1: Checking Voltage Between Front Power Window Switch Connector D35 Terminals 8 And 9 And Ground
    G03358874Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK HARNESS CONTINUITY 
    1. Turn ignition switch OFF.
    2. Disconnect front power window switch (passenger side) and front power window regulator (passenger side) connector.
    3. Check continuity between front power window switch (passenger side) connector D35 terminals 8, 9 and front power window regulator (passenger side) connector D36 terminals 1, 2.
      1. 8 (L) - 2 (L) : Continuity should exist. 
      2. 9 (G) - 1 (G) : Continuity should exist. 

    OK or NG

    1. OK : Replace front power window motor (passenger side).
    2. NG : Repair or replace harness between front power window switch (passenger side) and front power window regulator (passenger side).
    Fig 2: Checking Continuity Between Front Power Window Switch (Passenger Side) Connector D35 Terminals 8, 9 And Front Power Window Regulator (Passenger Side) Connector D36 Terminals 1, 2
    G03358875Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.