2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

  1. RETIGHTEN GROUND SCREWS 
    1. Turn ignition switch OFF.
    2. Loosen and retighten engine ground screws.
    3. Fig 1: Identifying Engine Ground
      G00778056Courtesy of NISSAN MOTOR CO., U.S.A.
    1. GO TO 2.
  2. CHECK PSP SENSOR POWER SUPPLY CIRCUIT 
    1. Disconnect PSP sensor harness connector.
    2. Turn ignition switch ON.
      Fig 2: Disconnecting PSP Sensor
      G00778057Courtesy of NISSAN MOTOR CO., U.S.A.
    3. Check voltage between PSP sensor terminal 1 and ground with CONSULT-II or tester.

      Voltage: Approximately 5V 

    4. Fig 3: Checking Voltage Between PSP Sensor Terminal 1 & Ground
      G00778058Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    1. OK: GO TO 3.
    2. NG: Repair open circuit or short to ground or short to power in harness or connectors.
  3. CHECK PSP SENSOR GROUND CIRCUIT FOR OPEN AND SHORT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Disconnect TCM harness connector (A/T models).
    4. Check harness continuity between PSP sensor terminal 3 and ECM terminal 67, TCM terminal 42 (A/T models).

      Continuity should exist. 

    5. Also check harness for short to power.

    OK or NG 

    1. OK: GO TO  5.
    2. NG: GO TO 4.
  4. DETECT MALFUNCTIONING PART 

    Check the following.

    • Harness for open or short between power steering pressure sensor and ECM
    • Harness for open or short between power steering pressure sensor and TCM (A/T models)

      Repair open circuit or short to power in harness or connectors.

  5. CHECK PSP SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Disconnect ECM harness connector.
    2. Check harness continuity between ECM terminal 12 and PSP sensor terminal 2.

      Continuity should exist. 

    3. Also check harness for short to ground and short to power.

    OK or NG 

    1. OK: GO TO 6.
    2. NG: Repair open circuit or short to ground or short to power in harness or connectors.
  6. CHECK PSP SENSOR 

    Refer to "COMPONENT INSPECTION " .

    OK or NG 

    1. OK: GO TO 7.
    2. NG: Replace PSP sensor.
  7. CHECK INTERMITTENT INCIDENT 

    Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".

    1. INSPECTION END 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.