2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Miscellaneous

MISCELLANEOUS LOCATION

Component Location
A/C Compressor (E36) Front of engine. See Figure .
A/T Device (M44) Front of center console. See Figure .
Audio Amplifier (B53, B54) Center front of trunk. See Figure .
Battery (Positive) (E28) Front left side of engine compartment. See Figure .
Condenser (1.8L SULEV) (F19) Top right side if engine. See Figure .
Condenser (1.8L ULEV) (F19) Top right side of engine. See Figure .
Condenser (2.5L) (F21) Top right rear of engine. See Figure .
Data Link Connector (M8) Under left side of dash. See Figure .
Diode-2 (M53) Behind right side of dash. See Figure .
Diode-3 (M55) Behind left side of dash. See Figure .
Diode-4 (B33) Near left front of trunk. See Figure .
Diode-5 Behind left side of dash. See Figure .
Dropping Resistor (E6) Front left side of engine compartment. See Figure .
Fan Resistor (M56) Behind right side of dash. See Figure .
Generator (E33, E34, E35) Front of engine. See Figure .
Horn (E29) Front of engine compartment. See Figure .
Ignition Coil No. 1 (1.8L SULEV) (F13) Top front of engine. See Figure .
Ignition Coil No. 1 (1.8L ULEV) (F13) Top front of engine. See Figure .
Ignition Coil No. 1 (2.5L) (F5) Top front of engine. See Figure .
Ignition Coil No. 2 (1.8L SULEV) F11) Top front of engine. See Figure .
Ignition Coil No. 2 (1.8L ULEV) (F11) Top front of engine. See Figure .
Ignition Coil No. 2 (2.5L) (F6) Top front of engine. See Figure .
Ignition Coil No. 3 (1.8L SULEV) (F9) Top front of engine. See Figure .
Ignition Coil No. 3 (1.8L ULEV) (F9) Top front of engine. See Figure .
Ignition Coil No. 3 (2.5L) Top front of engine. See Figure .
Ignition Coil No. 4 (1.8L SULEV) (F7) Top front of engine. See Figure .
Ignition Coil No. 4 (1.8L ULEV) (F7) Top front of engine. See Figure .
Ignition Coil No. 4 (2.5L) Top front of engine. See Figure .
Joint Connector-1 (1.8L SULEV) (F24) Right side of dash. See Figure .
Joint Connector-1 (1.8L ULEV) (F24) Right side of dash. See Figure .
Joint Connector-1 (2.5L) (F1) Right side of dash. See Figure .
Rear Window Defogger (B34, B201) Rear window. See Figure .
Seat Belt Pre-Tensioner (Front Left) (B22) Base of left "B" pillar. See Figure .
Seat Belt Pre-Tensioner (Front Right) (B16) Base of right "B" pillar. See Figure .
Spiral Cable (M36) In steering column. See Figure .
Terminal Cord Assembly (A/T) (1.8L SULEV) (F50) Left front of engine compartment. See Figure .
Terminal Cord Assembly (A/T) (1.8L ULEV) (F50) Left front of engine compartment. See Figure .
Terminal Cord Assembly (A/T) (2.5L) (F30) Left front of engine compartment. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.