WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Power is supplied at all times

To BCM terminal 55
Through 50A fusible link (letter j, located in the fuse and fusible link box).
To BCM terminal 42
Through 15A fuse [No. 3, located in the fuse block (J/B)].

When the key switch is ON, power is supplied

To BCM terminal 37
Through key switch terminals 1 and 2
Through 15A fuse [No. 19, located in the fuse block (J/B)].

When the key switch is ACC or ON, power is supplied

To BCM terminal 11
Through 10A fuse [No. 4, located in the fuse block (J/B)].

When the key switch is ON or START, power is supplied

To BCM terminal 38
Through 10A fuse [No. 16, located in the fuse block (J/B)].

When the front door switch LH is ON (door is OPEN), ground is supplied

To BCM terminal 62
Through front door switch LH terminal 1
To front door switch LH case ground.

When the front door switch RH is ON (door is OPEN), ground is supplied

To BCM terminal 12
Through front door switch RH terminal 1
To front door switch RH case ground.

When the sliding door switch LH is ON (door is OPEN), ground is supplied

To BCM terminal 63
Through sliding door switch LH terminal 1
To sliding door switch LH case ground.

When the sliding door switch RH is ON (door is OPEN), ground is supplied

To BCM terminal 13
Through sliding door switch RH terminal 1
To sliding door switch RH case ground.

When the back door switch is ON (door is OPEN), ground is supplied

To BCM terminal 58
Through back door switch terminal 1 (without back door closure system) or,
Through back door latch terminal 7 (with back door closure system)
Through back door switch terminal 3 (without back door closure system),.
Through back door latch terminal 8 (with back door closure system),.
To body grounds D403 and D404.

Key fob signal is inputted to BCM from the remote keyless entry receiver.

The remote keyless entry system controls operation of the

Power door lock
Sliding door opener
Back door opener
Interior lamp and step lamps
Panic alarm
Hazard and horn reminder
Keyless power window down (open)
Auto door lock operation

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

System Description: Inputs

Use the Manual With the Right Hardware

When to See a Mechanic