2003 Nissan-Datsun Sentra SE-R, StandardFACTORY OEM SERVICE PROCEDURE

Check Trunk Lid Opener Cancel Switch

WARNING: This page is about a different car, the 2003 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect trunk lid opener cancel switch connector.
    3. Check voltage between trunk lid opener cancel switch connector M117 terminal 1 (G) and ground.
      1. 1 (G) - Ground :Battery voltage 
      4. Fig 1: Checking Voltage Between Trunk Lid Opener Cancel Switch Connector And Ground
      G02022403Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK >> GO TO 2.

    NG >> Check the following.

    • Trunk lid opener relay
    • Harness for open or short between trunk lid opener cancel switch and trunk lid opener relay

  2. CANCEL SWITCH INSPECTION 

    Check continuity between trunk lid opener cancel switch terminals 1 and 2.

    Fig 2: Identifying Switch Inspection Table
    G02022404Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.