2003 Nissan-Datsun Sentra SE-R, StandardFACTORY OEM SERVICE PROCEDURE

Checking Radiator Cap

WARNING: This page is about a different car, the 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
  • Check valve seat of radiator cap.
    • Check if valve seat is swollen to the extent that the edge of the plunger cannot be seen when watching it vertically from the top.
    • Check if valve seat has no soil and damage.
    Fig 1: Checking Radiator Cap
    G02358637Courtesy of NISSAN MOTOR CO., U.S.A.
  • Pull negative-pressure valve to open it, and make sure that it close completely when released.
    • Make sure that there is no dirt or damage on the valve seat of radiator cap negative-pressure valve.
    • Make sure that there are no unusualness in the opening and closing conditions of negative-pressure valve.
    Fig 2: Pulling Negative-Pressure Valve
    G02358638Courtesy of NISSAN MOTOR CO., U.S.A.
  • Check radiator cap relief pressure.
    1. Standard: 
      1. 78 - 98 kPa (0.8 - 1.0 kg/cm 2  , 11 - 14 psi) 
    2. Limit: 
      1. 59 kPa (0.6 kg/cm 2  , 9 psi) 
    • When connecting radiator cap to the radiator cap tester (commercial service tool) and the radiator cap tester adapter [SST], apply engine coolant to the cap seal surface.
    Fig 3: Checking Radiator Cap Relief Pressure
    G02358639Courtesy of NISSAN MOTOR CO., U.S.A.
  • Replace radiator cap if there is an unusualness related to the above three.
CAUTION: When installing radiator cap, thoroughly wipe out the radiator filler neck to remove any waxy residue or foreign material.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.