Move selector lever from the P position to the 1 position. You should be able to feel the detents in each position. If the detents cannot be felt or the pointer indicating the position is improperly aligned, the control cable needs adjustment.

Place selector lever in P position.
Loosen control cable lock nut and place manual shaft in P position.
CAUTION: Turn wheels more than 1/4 rotations and apply the park lock.
Push control cable in the direction of the arrow shown in the illustration by specified force.
Specified force: 4.9 - 9.8 N (0.5 - 1.0 kg, 1.1 - 2.2 lb)
Tighten control cable lock nut.
Move selector lever from P to 1 position again. Make sure that selector lever moves smoothly.
- Make sure that the starter operates when the selector lever is placed in the N or P position.
- Make sure that the transmission is locked properly when the selector lever is placed in the P position.
Fig 1: Loosening Control Cable Lock Nut And Placing Manual Shaft In P Position
Courtesy of NISSAN MOTOR CO., U.S.A.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Control Cable Adjustment

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?