Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE
Diagnostic Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECTION START (WITH CONSULT-II)
With CONSULT-II
- Turn ignition switch "ON" and select "SELF DIAGNOSIS" mode for A/T with CONSULT-II.
- Touch "ERASE".
- GO TO 2.
- CHECK DTC
Perform "DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE ".
- GO TO 3.
- CHECK DTC AGAIN
Is the "CONTROL UNIT (RAM)" or "CONTROL UNIT (ROM)" displayed again?
Yes or No
- Yes: Replace TCM.
- No: INSPECTION END
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
