2003 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Control Valve Upper Body: Assembly: Notes

WARNING: This page is about a different variant/trim than selected.
  • Lay control valve body down when installing valves. Do not stand the control valve body upright.Β 
    Fig 1: Identifying Right And Wrong Way Of Keeping Control Valve Body
    G01319628Courtesy of NISSAN MOTOR CO., U.S.A.
  1. Lubricate the control valve body and all valves with ATF. Install control valves by sliding them carefully into their bores.
    Fig 2: Lubricating Control Valve Body And All Valves With ATF
    G01319629Courtesy of NISSAN MOTOR CO., U.S.A.
    • Be careful not to scratch or damage valve body.Β 
    • Wrap a small screwdriver with vinyl tape and use it to insert the valves into their proper positions.
    Fig 3: Inserting Valves Into Their Proper Positions
    G01319630Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.