Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Consult-II Inspection Procedure
- Turn ignition switch OFF.
- Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
- Turn ignition switch ON.
- Turn ASCD main switch ON.
- Touch START (NISSAN BASED VHCL) (on CONSULT-II display).
- Touch ASCD.
If "ASCD" is not indicated, go to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .
- Touch SELF-DIAG RESULTS.
- Self-diagnostic results are shown on display
Refer to CONSULT-II SELF-DIAGNOSTIC RESULTS .
- Self-diagnostic results are shown on display
- Touch DATA MONITOR.
- Touch START.
- Data monitor results are shown on display
Refer to CONSULT-II SELF-DIAGNOSTIC RESULTS .
For further information, read the CONSULT-II Operation Manual .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.