2003 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Adjustment Of A/T Position

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen nut of control cable.
  2. Place PNP switch and selector lever in "P" position.
  3. After pushing the control cable in the direction shown with a force of 9.8 N.m (1 kg-m, 2.2 lb-ft), release it. This is in the natural state, tighten control cable nut to specifications.
  1. Control cable nut : 14.5 N.m (1.5 kg-m, 11 ft-lb)Β 
    Fig 1: Pushing The Control Cable
    G00726742Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.