2003 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Consult-II Operation

WARNING: This page is about a different car, the 2005 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.
  1. With the ignition switch OFF, connect CONSULT-II and CONSULT- II CONVERTER to the data link connector, then turn the ignition switch ON.
    Fig 1: Identifying Data Link Connector Location
    G03597192Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Touch "START (NISSAN BASED VHCL)".
    Fig 2: CONSULT-II Screen Display - START (NISSAN BASED VHCL)
    G03597193Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Touch "IPDM E/R" on "SELECT SYSTEM" screen.

    If "IPDM E/R" is not displayed, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

    Fig 3: CONSULT-II Screen Display - Select System (IPDM E/R)
    G03597194Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Select the desired part to be diagnosed on the "SELECT DIAG MODE" screen.
    Fig 4: Selecting Diag Mode - Auto Light System
    G03597195Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.