Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE
Section 122 (Instrument Panel)
WARNING: This page is about a different car, the 2003 Lexus ES 300 and 2002 Lexus ES 300. However, it is still accessible from the selected car via links, so may be relevant.
- Description & Operation
- Component Locations
- Trouble Shooting
- Function Tests
- Self-Diagnostic System
- System Tests
- Notes
- Test A: Malfunction In Speedometer
- Test B: Malfunction In Tachometer
- Test C: Malfunction In Water Temperature Receiver Gauge
- Test D: Malfunction In Fuel Receiver Gauge
- Test E: Operating Light Control Rheostat Does Not Change Light Brightness
- Test F: Entire Combination Meter Does Not Operate
- Test G: Buzzer Does Not Sound (Key Reminder Warning, Seat Belt Warning)
- Test H: Seat Belt Warning Lamp For Driver's Seat Does Not Operate
- Test I: Seat Belt Warning Lamp For Front Passenger's Seat Does Not Flash
- Test J: Malfunction In Clock Display
- Test K: Multi-Information Display Screen Does Not Change When Steering Pad Switch Is Operated
- Test L: Malfunction In Average Fuel Consumption/Instantaneous Fuel Consumption/Possible Running Distance Display
- Component Tests
- Pin Voltage Charts
- Removal & Installation
- Torque Specifications
- Connector Identification
- Wiring Diagrams
- Special Tools
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.