2003 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Section 1177 (Front Axle): Precautions: Precautions

WARNING: This page is about a different car, the 2004 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
  • When installing rubber parts, final tightening must be carried out under unladen condition* with tires on ground.Β 

    *: Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.Β 

  • After installing removed suspension parts, check wheel alignment and adjust if necessary.Β 
  • Use flare nut wrench when removing or installing brake tubes.Β 
  • Always torque brake lines when installing.Β 
Fig 1: Identifying Special Tools
G00903234Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.