WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Be sure to read the explanation of Driving Pattern on TEST VALUE AND TEST LIMIT (GST ONLY - NOT APPLICABLE TO CONSULT-II) before driving vehicle.

Start engine.
Drive vehicle according to Driving Pattern, TEST VALUE AND TEST LIMIT (GST ONLY - NOT APPLICABLE TO CONSULT-II) .
Stop vehicle.
Select MODE 1 with GST.
- If SRT of EVAP system is not set yet, go to the following step.
- If SRT of EVAP system is set, the result will be OK.
Turn ignition switch OFF and wait at least 10 seconds.
Start engine.
It is not necessary to cool engine down before driving.
Drive vehicle again according to the Driving Pattern, TEST VALUE AND TEST LIMIT (GST ONLY - NOT APPLICABLE TO CONSULT-II) .
Stop vehicle.
Select MODE 3 with GST.
- If P0442 is displayed on the screen, go to "DIAGNOSTIC PROCEDURE ".
- If P0441 is displayed on the screen, go to "DIAGNOSTIC PROCEDURE " for DTC P0441,
- If P0441 and P0442 are not displayed on the screen, go to the following step.
Select MODE 1 with GST.
- If SRT of EVAP system is set, the result will be OK.
- If SRT of EVAP system is not set, go to step 6.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

With GST

Use the Manual With the Right Hardware

When to See a Mechanic