Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2003 Nissan-Datsun Sentra SE-R Spec VFACTORY OEM SERVICE PROCEDURE

Base System

WARNING: This page is about a different car, the 2006 Nissan Xterra. However, it is still accessible from the selected car via links, so may be relevant.

Refer to Owner's Manual for audio system operating instructions. Power is supplied at all times

through 20A fuse (No. 29, located in the fuse and fusible link box)
to audio unit terminal 6.
With the ignition switch in the ACC or ON position, power is supplied
through 10A fuse [No. 4, located in the fuse block (J/B)]
to audio unit terminal 10.
Ground is supplied through the case of the audio unit. Then audio signals are supplied
through audio unit terminals 1, 2, 3, 4,13,14,15 and 16
to terminals + and - of front door speaker LH and RH
to terminals + and - of front tweeter LH and RH
to terminals + and - of rear door speaker LH and RH.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.