Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Nissan-Datsun Sentra SE-R, StandardFACTORY OEM SERVICE PROCEDURE
General Specifications
WARNING: This page is about a different variant/trim than selected.
General Specifications
| Engine | QG18DE | |||
| Automatic transaxle model | RE4F03B | |||
| Automatic transaxle assembly | Model code number | 3AX60 | ||
| Transaxle gear ratio | 1st | 2.861 | ||
| 2nd | 1.562 | |||
| 3rd | 1.000 | |||
| 4th | 0.698 | |||
| Reverse | 2.230 | |||
| Final drive | 3.827 | |||
| Recommended fluid | Nissan Matic "D" (Continental U.S. and Alaska) or Genuine Nissan Automatic Transmission Fluid (Canada)(1) | |||
| Fluid capacity | 7.0l (7-3/8 US qt, 6-1/8 lmp qt) | |||
|
||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.