Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Nissan-Datsun Sentra SE-R, StandardFACTORY OEM SERVICE PROCEDURE
AV Switch Check
WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
- AV SWITCH SELF-DIAGNOSIS FUNCTION CHECK
- Perform AV switch self-diagnosis function. Refer to AV SWITCH SELF-DIAGNOSIS FUNCTION .
Does AV switch operate normally?
- YES: INSPECTION END.
- NO: GO TO 2.
- CHECK AV SWITCH POWER SUPPLY AND GROUND CIRCUIT
- Check AV switch power supply and ground circuit. Refer to POWER SUPPLY AND GROUND CIRCUIT CHECK FOR AV SWITCH
OK or NG
- YES: Replace AV switch. Refer to , "REMOVAL AND INSTALLATION FOR AV SWITCH ".
- NO: Repair malfunctioning part.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.