2002 Nissan-Datsun Sentra SE-R, StandardFACTORY OEM SERVICE PROCEDURE

Refrigerant Lines: Components

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front A/C Compressor And Condenser
G00866899Courtesy of NISSAN MOTOR CO., U.S.A.
  1. High-pressure service valve
  2. Low-pressure service valve
  3. High-pressure pipe
  4. Refrigerant pressure sensor
  5. Low-pressure flexible hose
  6. High-pressure flexible hose
  7. Shaft seal
  8. Condenser
  9. Liquid tank
  10. Pressure relief valve
  11. Compressor
  12. Expansion valve (front)
  13. High/low pressure pipe
Fig 2: Identifying Rear A/C
G00866900Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.