2002 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Brake Pedal Height

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

Check brake pedal free height "H" and depressed height "D" from floor panel to top of brake pedal pad. See Fig 1. See BRAKE PEDAL HEIGHTΒ  table. To adjust brake pedal height, loosen lock nut and turn brake booster input rod. Tighten lock nut to 12-15 ft. lbs. (16-22 N.m). Ensure rod tip stays inside input rod clevis.

Fig 1: Adjusting Brake Pedal Height
G94G46462Courtesy of NISSAN MOTOR CO., U.S.A.
BRAKE PEDAL HEIGHT

Application In. (mm)
Free Height "H" 7.85-8.25 (199.5-209.5)
Depressed Height "D"(1) 4.72 (120) Or More
(1) Under force of 110 lbs. (50 kg) with engine running.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.