2002 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Differential Assembly

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove differential side shaft assembly. Refer to "DIFFERENTIAL SIDE SHAFTΒ ".
  2. Remove side seal from gear carrier using suitable tool.
  3. For proper reinstallation, paint matching marks on one side of the side bearing cap and gear carrier.
    CAUTION:
    • For matching marks, use paint. Do not damage side bearing cap or gear carrier.
    • Side bearing caps are line-board during manufacture. The matching marks are used to reinstall them in their original positions.
      Fig 1: Aligning Matching Mark On Bearing Cap With Gear Carrier
      G04901855
  4. Remove the side bearing caps.
    Fig 2: Identifying Bearing Caps
    G04901856
  5. Lift the differential case assembly out of the gear carrier.
    CAUTION:
    • Keep side bearing outer races together with side bearing inner races. Do not mix them up.
    • Keep side bearing adjusting washers together with side bearings.
      Fig 3: Lifting Differential Case Assembly
      G04876422
  6. Remove housing spacer.
  7. Remove side bearing inner race using Tools as shown.

    Tool number A: ST33051001 (J-22888-20)Β 

    B: ST33061000 (J-8107-2)Β 

    CAUTION:
    • Do not remove side bearing inner race unless it is being replaced.
    • Place copper plates between the vise and the side bearing inner race and drive gear to prevent damage.
      Fig 4: Identifying Side Bearing Inner Races
      G04898702
    • Keep side bearing outer races together with side bearing inner races. Do not mix them up.
      Fig 5: Identifying Left And Right Side Parts Label
      G04901860
  8. For proper reinstallation, paint matching marks on the differential case and drive gear.
    CAUTION: Use paint for matching marks. Do not damage differential case or drive gear.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.