Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE
Disc Brake
WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
DISC BRAKE SPECIFICATION
| Unit: mm (in) | |||
| Brake model | AD35VB (Front) | AD14VE (Rear) | |
| Pad wear limit | Minimum thickness | 2.0 (0.079) | 2.0 (0.079) |
| Rotor repair limit | Maximum runout | 0.04 (0.0016) | 0.05 (0.0020) |
| Minimum thickness | 26.0 (1.02) | 14.0 (0.55) | |
| Maximum thickness variation (measured at 8 positions) | 0.015 (0.0006) or less | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.