Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE
System Description: Operation: Notes
WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
Power is supplied at all times
- Through 50A fusible link (letter f, located in the fuse and fusible link box)
- To BCM terminal 70, and
- Through BCM terminal 69
- To sunroof motor assembly terminal 5.
With ignition switch in ON or START position, power is supplied
- Through 10A fuse (No. 59, located in the fuse and relay box)
- To BCM terminal 38.
Ground is supplied
- To BCM terminal 67 and
- To sunroof motor assembly terminal 7
- Through grounds M57, M61 and M79.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.