Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Room/Map Lamp Assembly Control Does Not Operate
- CHECK EACH SWITCHÂ
Select "BCM" on CONSULT-II. With "INT LAMP" data monitor, make sure switches listed in display item list turn ON-OFF linked with switch operation. Refer to "DISPLAY ITEM LISTÂ " for switches and their functions.
OK or NGÂ
- OK: GO TO 2.
- NG: Inspect malfunctioning switch system.
- ACTIVE TESTÂ
- Select "BCM" on CONSULT-II. Select "INT LAMP" active test.
- When switch is in "DOOR" position, use active test to make sure interior room lamp operates.
Room lamps should turn on .
OK or NGÂ
- OK: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".
- NG: GO TO 3.
- CHECK FRONT ROOM/MAP LAMP ASSEMBLY INPUTÂ
- Turn ignition switch OFF.
- Check voltage between front room/map lamp assembly harness connector R102 terminal 6 (R/G) and ground.
6 (R/G) - Ground: Battery voltage should exist .
OK or NGÂ
- OK: GO TO 4.
- NG: GO TO 5.
- CHECK FRONT ROOM/MAP LAMP ASSEMBLY CIRCUITÂ
- Disconnect BCM connector.
- Check continuity between BCM harness connector M20 terminal 63 (L) and front room/map lamp assembly harness connector R102 terminal 1 (L).
63 (L) - 1 (L): Continuity should exist .
OK or NGÂ
- OK: Replace front room/map lamp assembly.
- NG: Repair harness or connector.
- CHECK FRONT ROOM/MAP LAMP ASSEMBLY CIRCUITÂ
- Disconnect BCM connector and interior room lamp connector.
- Check continuity between BCM harness connector M20 terminal 56 (R/G) and front room/map lamp assembly harness connector R102 terminal 6 (R/G).
56 (R/G) - 6 (R/G): Continuity should exist .
OK or NGÂ
- OK: Replace BCM if interior lamp does not work after setting the connector again. Refer to "REMOVAL AND INSTALLATION OF BCM ".
- NG: Repair harness or connector between BCM and room/map lamp.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
