2002 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Unified Control Meter: Notes

WARNING: This page is about a different car, the 2002 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Speedometer, "Odo/Trip" meter, tachometer, fuel gauge and water temperature gauge are controlled totally by control unit built-in combination meter. For combination meter components, see Fig 1.

Digital meter is adopted for "Odo/Trip" meter. The record of the odometer is kept even if the battery cable is disconnected. The record of the trip meter is erased when the battery cable is disconnected. "Odo/Trip" meter segment and meter/gauge can be checked in diagnosis mode.

Fig 1: Identifying Combination Meter Gauges, Indicator Lights, Bulb Sockets & Connector Terminal Pins
G00218342Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.