2002 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Concept of Auto Active Test

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  • IPDM E/R actuates auto active test mode when it receives door switch signal from BCM via CAN communication line. Therefore, when auto active test mode is activated successfully, CAN communication between IPDM E/R and BCM is normal.
  • If any of the systems controlled by IPDM E/R cannot be operated, possible cause can be easily diagnosed using auto active test.

Diagnosis chart in auto active test mode

AUTO ACTIVE TEST MODE DIAGNOSIS

Symptom Inspection contents Possible cause
Any of front wipers, tail and parking lamps, front fog lamps, cornering lamps, and head lamps (Hi, Lo) do not operate. Perform auto active test. Does system in question operate? YES
  • BCM signal input system
NO
  • Lamp/wiper motor malfunction
  • Lamp/wiper motor ground circuit malfunction
  • Harness/connector malfunction between IPDM E/R and system in question
  • IPDM E/R (integrated relay) malfunction
Rear window defogger does not operate. Perform auto active test. Does rear window defogger operate? YES
  • BCM signal input circuit
NO
  • Rear window defogger relay circuit
  • Open circuit of rear window defogger
  • IPDM E/R malfunction
A/C compressor does not operate. Perform auto active test. Does magnetic clutch operate? YES
  • BCM signal input circuit
  • CAN communication signal between BCM and ECM.
  • CAN communication signal between ECM and IPDM E/R
NO
  • Magnetic clutch malfunction
  • Harness/connector malfunction between IPDM E/R and magnetic clutch
  • IPDM E/R (integrated relay) malfunction
Cooling fan does not operate. Perform auto active test. Does cooling fan operate? YES
  • ECM signal input circuit
  • CAN communication signal between ECM and IPDM E/R
NO
  • Cooling fan motor malfunction
  • Harness/connector malfunction between IPDM E/R and cooling fan motor
  • IPDM E/R (integrated relay) malfunction
Β 
Oil pressure warning lamp does not operate. Perform auto active test. Does oil pressure warning lamp blink? YES
  • Harness/connector malfunction between IPDM E/R and oil pressure switch
  • Oil pressure switch malfunction
ON
  • CAN communication signal between BCM and Unified Meter and A/C Amp
  • Combination meter
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.