Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE
ABS Data Monitor Procedure
WARNING: This page is about a different car, the 2002 Nissan Altima. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch "OFF".
- Connect CONSULT-II to Data Link Connector (DLC). See Figure .
- Turn ignition switch "ON".
- Touch "START" on CONSULT-II screen.
- Touch "ABS".
- Touch "DATA MONITOR".
- Touch "SETTING" on "SELECT MONITOR ITEM" screen.
- Touch "LONG TIME" on "SET RECORDING COND" screen.
- Touch "START" on "SELECT MONITOR ITEM". For monitor items, see Fig 1 .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.