2002 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Display with Pushed "ROUTE" button

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  • Easy Mode
    Fig 1: Display With Pushed Route Button (Easy Mode)
    G02477271Courtesy of NISSAN MOTOR CO., U.S.A.
  • Expert Mode
    Fig 2: Display With Pushed Route Button (Expert Mode)
    G02477272Courtesy of NISSAN MOTOR CO., U.S.A.

The function of each icon is as follows: 

ICON DESCRIPTION

Icon Mode Description
Easy Expert
Quick Stop X X The selected facility is set as the destination or waypoint. (Route guidance has been turned OFF or the destination has been reached.)
Where am I? X X Next, current and previous street names can be displayed.
Cancel Guidance X X The following items can be selected.
  • All Destinations
  • Way point
  • Not Cancel
Route Info.(1)   X The following items can be selected.
  • Complete Route
  • Turn List
  • Route Simulation

    (Displayed only when the destination area has been set.)
Edit Route(1)   X Change the destination or add the transit points of the route set in the route guide. (Displayed only when the automatic reroute function has been turned OFF and the recommended route is not followed.)
Help X   Explanation of navigational functions appear on the display.
(1) When destinations have been entered, route guidance has been turned OFF or destination has been reached, "Route Info." and "Edit Route" are not displayed.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.