2002 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

"Multi Remote ENT"

  1. Turn ignition switch "OFF".
    Fig 1: Inspecting CONSULT-II Procedure
    G02053798Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Connect "CONSULT-II" to the data link connector.
  3. Turn ignition switch "ON".
    Fig 2: CONSULT-II Display
    G02053799Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Touch "START".
  5. Touch "SMART ENTRANCE".
    Fig 3: CONSULT-II Select System
    G02053800Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Touch "MULTI REMOTE ENT".
    Fig 4: CONSULT-II Select Test Mode
    G02053801Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Select diagnosis mode.

    "DATA MONITOR", "ACTIVE TEST" and "WORK SUPPORT" are available.

Fig 5: CONSULT-II Select Diag Mode
G02053802Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.