Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Check Electronic Key
- CHECK ELECTRONIC KEY
With CONSULT-II
Check Electronic key "LOCK/UNLOCK BUTTON", "TRUNK BTN-CON" and "PANIC BTN" in "DATA MONITOR" mode with CONSULT-II.
Without CONSULT-II
Check electronic key in "SWITCH MONITOR" mode. Refer to SWITCH MONITOR .
OK or NG
- OK: Electronic key is OK.
- NG: GO TO 2.
- CHECK ELECTRONIC KEY ID
With CONSULT-II
Check electronic key "ID Code" in "WORK SUPPORT" mode with CONSULT-II. Refer to PROCEDURE 2 (WITH CONSULT-II) .
Without CONSULT-II
Check electronic key "ID Code" in "REMOTE CONTROLLER ID SET UP" mode. Refer to PROCEDURE 1 (WITHOUT CONSULT-II) .
OK or NG
- OK: Electronic key was not registered.
- NG: Check multi remote control receiver.
Refer to Check Remote Keyless Entry Receiver .
- Check electronic key battery.
Refer to Electronic Key Battery Replacement .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.