2002 Nissan-Datsun Sentra SE-R Spec VFACTORY OEM SERVICE PROCEDURE

Torque Specifications

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

For 2003 Torque Specifications, see TORQUE SPECIFICATIONS  table. For 2004 Torque Specifications, see DISC BRAKES under BRAKES in 2004 SPECIFICATIONS - MURANO article in GENERAL INFORMATION.

TORQUE SPECIFICATIONS (2003)

Application Ft. Lbs. (N.m)
Booster Mount Nut 12-15 (15.7-21.6)
Brake Booster Push Rod Lock Nut 14 (18.6)
Brake Hose To Caliper Mounting Bolt 13-14 (16.7-19.6)
Brake Pedal Bracket Nut 10-11 (12.7-15.7)
Flare Nut 11-13 (15-18)
Front Caliper-To-Torque Member Bolt 17-22 (22-31)
Front Hub Nut 74-111 (100-150)
Front Torque Member 101-129 (137-176)
Pressure Sensor (VDC Model Master Cylinder) 11-14 (15-19)
Rear Caliper-To-Torque Member Bolt 28-35 (38-48)
Rear Hub Nut (AWD) 74-111 (100-150)
Rear Torque Member 53-71 (71.6-97.0)
Wheel Lug Nuts 72-94 (98-127)
INCH Lbs. (N.m) 
Brake Bleeder Screw 61-78 (7-9)
Master Cylinder To Booster 108-120 (11.7-14.6)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.