2002 Nissan-Datsun Sentra SE-R Spec VFACTORY OEM SERVICE PROCEDURE

KEYFOB Id Set Up With Consult-II

NOTE: If a keyfob is lost, the ID code of the lost keyfob must be erased to prevent unauthorized use. When the ID code of a lost keyfob is not known, all keyfob ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new keyfobs must be re-registered.
  1. Turn ignition switch "OFF".
    Fig 1: Checking Harness Open Or Short Between Smart Entrance Control Unit And Interior Lamp
    G02053836Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Connect "CONSULT-II" to the data link connector.
  3. Turn ignition switch "ON".
    Fig 2: CONSULT-II Display
    G02053837Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Touch "START".
  5. Touch "SMART ENTRANCE".
    Fig 3: CONSULT-II Select System
    G02053838Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Touch "MULTI REMOTE ENT".
    Fig 4: CONSULT-II Select Test Item
    G02053839Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Touch "WORK SUPPORT".
    Fig 5: CONSULT-II Select Diag Mode
    G02053840Courtesy of NISSAN MOTOR CO., U.S.A.
  8. The items are shown that can be set up.
    • "REMO CONT ID CONFIR"

      Use this mode to confirm if a keyfob ID code is registered or not.

    • "REMO CONT ID REGIST"

      Use this mode to register a keyfob ID code.

      NOTE: Register the ID code when keyfob or smart entrance control unit is replaced, or when additional keyfob is required.
    • "REMO CONT ID ERASUR"

      Use this mode to erase a keyfob ID code.

    • "HZRD REM SET"

      Use this mode to activate or deactivate the hazard and horn reminder.

      Fig 6: Condult II Select Work Item
      G02053841Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.