2002 Nissan-Datsun Sentra SE-R Spec VFACTORY OEM SERVICE PROCEDURE

Time Control Unit Inspection Table (Without Power Door Locks)

TIME CONTROL UNIT INSPECTION

Terminal No. Wire color Connections Operated condition Voltage (Approx.)
1 W/B Seat belt buckle switch LH Unfasten --> Fasten (Ignition key is in "ON" position) 0v --> 5v
2 R Front door switch LH OFF (Closed) --> ON (Open) 5v --> 0v
3 G/B Air control (Rear window defogger switch) OFF --> ON 5v --> 0v
4 L/W Ignition key switch (Insert) Key Inserted --> Key removed from IGN Key cylinder 12v --> 0v
5 R/G Combination switch (Lighting switch) 1ST, 2ND positions: ON --> OFF 12v --> 0v
7 PU Power source (Fuse) - 12V
8 B Ground - -
9 G Ignition switch (ON, START) Ignition key is in "ON" or "START" position 12V
10 G/R Rear window defogger relay OFF --> ON (Ignition key is in "ON" position) 0V --> 12V
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.