2002 Nissan-Datsun Sentra SE-R L4-2.5L (QR25DE)FACTORY OEM SERVICE PROCEDURE

Preparation





ECM Harness Connector Terminal Layout:

Factory service manual diagram





ECM Terminals and Reference Value

PREPARATION

Factory service manual diagram



1. ECM is located in the right side of the cowl top (behind the strut tower).
For this inspection:
- Remove front strut tower bar. Refer to "FRONT SUSPENSION ASSEMBLY". Suspension
- Remove engine control harness bracket on the strut tower.

Factory service manual diagram



- Remove quick connector on the ventilation hose.

Factory service manual diagram



- Remove ECM fixing bolts and pull it out all the way.

Factory service manual diagram



- Remove ECM cover fixing bolts.
- Remove ECM fixing bolts.
- Remove ECM with the harness from the cover.

Factory service manual diagram




2. Remove ECM harness protector.

Factory service manual diagram



3. Perform all voltage measurements with the connector connected. Extend tester probe as shown to perform tests easily.
- Open harness securing clip to make testing easier.
- Use extreme care not to touch 2 pins at one time.
- Data is for comparison and may not be exact.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.