2002 Nissan-Datsun Sentra SE-R L4-2.5L (QR25DE)FACTORY OEM SERVICE PROCEDURE

Computers/Controls - CONSULT(R) Reprogramming Info.

Classification: EC11-021A

Reference: NTB11-074A

Date: August 18, 2011

REPROGRAMMING WITH CONSULT

This bulletin has been amended. The statements below have changed. No other changes have been made. Please discard any previous copies.

APPLIED VEHICLES: All Nissan vehicles with a reprogrammable ECU

SERVICE INFORMATION

If you have a reprogram that requires the use of CONSULT-IT (C-II, and C-II is not available:

^ Refer to the chart below to determine CONSULT applicability.

Factory service manual diagram




CURRENT REPROGRAMMING APPLICABILITY CHART

Reprogramming C-II Loaner Program
(Available ONLY for reprogramming use)


^ Contact TECH LINE and they will determine if a C-II Loaner is needed. If so they will make arrangements for the loaner to be shipped.

^ Dealerships must return the C-II Loaner immediately after the reprogramming is completed.

^ If the Loaner is not returned within one week of delivery, your FOM will be contacted to collect the unit.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.