2001 Nissan-Datsun Pathfinder SE, RWD, StandardFACTORY OEM SERVICE PROCEDURE

Remote Controller Id Set Up With Consult-II

NOTE: If a remote controller is lost, the ID code of the lost remote controller must be erased to prevent unauthorized use. When the ID code of a lost remote controller is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new remote controllers must be re-registered.
  1. Turn ignition switch "OFF".
  2. Connect CONSULT-II to the data link connector.
    Fig 1: Identifying Data Link Connector
    G03147253
  3. Turn ignition switch "ON".
  4. Touch "START".
    Fig 2: Displaying START
    G03147254
  5. Touch "SMART ENTRANCE".
    Fig 3: Displaying SMART ENTRANCE In SELECT SYSTEM Mode
    G03147255
  6. Touch "MULTI REMOTE ENT".
    Fig 4: Displaying MULTI REMOTE ENT In SELECT TEST ITEM Mode
    G03147256
  7. Touch "WORK SUPPORT".
    Fig 5: Displaying WORK SUPPORT In SELECT DIAG MODE
    G03147257
  8. The items are shown on the figure at left can be set up.

    "REMO CONT ID CONFIR"

    Use this mode to confirm if a remote controller ID code is registered or not.

    "REMO CONT ID REGIST"

    Use this mode to register a remote controller ID code.

    NOTE: Register the ID code when remote controller or smart entrance control unit is replaced, or when additional remote controller is required.

    "REMO CONT ID ERASER"

    Use this mode to erase a remote controller ID code.

    "HZRD REM SET"

    Use this mode to activate or deactivate the hazard and horn reminder.

    Fig 6: Displaying SELECT WORK ITEM Mode
    G03147258
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.