1997 Nissan-Datsun Sentra BaseFACTORY OEM SERVICE PROCEDURE

Ignition Coil Power Source & Ground

  1. Disconnect 3-pin ignition coil connector. Turn ignition on. Check voltage between ground and terminal "1" (Red wire) of ignition coil connector.
  2. If voltage is present, go to next step. If voltage is not present, check continuity of entire circuit between battery and ignition coil, including fusible link and ignition switch.
  3. Turn ignition off. Check continuity between ground and ignition coil connector terminal "2" (Black wire). If continuity does not exist, repair ground circuit between ignition coil connector and ground. Repeat test for remaining coils.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.