1995 Nissan-Datsun Sentra BaseFACTORY OEM SERVICE PROCEDURE

Radiator (Cooling) Fan Control Test

WARNING: Be careful not to overheat engine during radiator fan control test.
  1. A fault in radiator fan control circuit may set DTC 28 (P1900). To test system, see DTC 28 (P1900) diagnostic procedures in the TESTS W/CODES article. To test radiator fan, go to next step.
  2. Start engine and warm to operating temperature. Turn A/C switch on. Turn blower fan switch on. Ensure radiator fan comes on. Turn ignition (engine) off. Turn A/C switch and fan switch off. Disconnect engine coolant temperature sensor harness connector.
  3. Connect a 150-ohm resistor to engine coolant temperature sensor harness connector. Start engine and ensure radiator fan comes on. If radiator fan operates as specified, cooling fan is functioning properly. If radiator fan does not operate as specified, go to RADIATOR FAN MOTOR TESTΒ  and DTC 28 (P1900) diagnostic procedures in the TESTS W/CODES article.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.