Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Nissan-Datsun Sentra BaseFACTORY OEM SERVICE PROCEDURE
Fuel Injector System Test
- With engine running, listen for clicking sound at each injector. If clicking sound is present at each injector, system is functioning properly. If clicking sound is not present, go to next step.
- Turn ignition off. Disconnect injector harness connector(s). Turn ignition on. Measure voltage between ground and injector harness connector Black/Red wires. Battery voltage should be present. If battery voltage is present, go to next step. If battery voltage is not present, check 30-amp fusible link and ignition switch. If fusible link and ignition switch are okay, repair or replace harness or connectors.
- Ensure ignition is off. Disconnect ECM harness connector. ECM is located under center of instrument panel. Check continuity between ECM harness connector terminals No. 102 (Red/Black wire), No. 104 (Green/Black wire), No. 107 (Yellow/Black wire), and No. 109 (Blue/Black wire) and corresponding fuel injector harness connector wire color. Continuity should exist.
- If continuity does not exist, repair or replace harness or connectors. If continuity exists, check fuel injector. See FUEL INJECTOR . If fuel injector is okay, check ECM terminals, harness and connector terminals for damage or corrosion. Repair or replace as necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.