Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Nissan-Datsun Sentra SE-R, StandardFACTORY OEM SERVICE PROCEDURE
Auxiliary Air Control (AAC) Valve Test (Maxima VG30E)
Check resistance between terminals No. 1 and 2; 2 and 3; 4 and 5; and 5 and 6 of AAC valve connector. See Fig 1 . If resistance is not 27-40 ohms at 68°F (20°C), replace AAC valve.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.