1993 Nissan-Datsun Sentra SE-R, AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel Pump Test

To test fuel pump, disconnect fuel pump connector, accessible through trunk (Maxima and 300ZX), under rear seat (Altima, NX and Sentra) or under vehicle body (Pathfinder, Pickup, Quest and 240SX). At fuel pump connector, check resistance between wire terminals specified in FUEL PUMP RESISTANCE TESTΒ  table. If resistance is not as specified, replace fuel pump.

FUEL PUMP RESISTANCE TEST

Application (1) Terminals (Wire Colors) (2) Ohms
Altima Black & Black/Red 0.5
Maxima Black & Red/Blue 0.5
NX & Sentra Black & Black/Red 0.7
Pathfinder Black & White/Blue 1.5
Pickup
2.4L Black & White/Blue (3)
3.0L Black & White/Blue 1.5
Quest Black/White & Light Green/Red 0.7
240SX Black & Black/Yellow 0.5
300ZX Orange & White 0.5
(1) If more than one Black wire is used at fuel pump connector, check resistance between wire specified in table and both Black wires at connector.
(2) Values are approximate.
(3) Ensure continuity exists.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.