Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine (Coolant) Temperature Sensor
Faults in engine (coolant) temperature sensor circuit may set Code 13. To test system, see CODE 13 diagnostic procedures in TESTS W/CODES article.
To test sensor, disconnect sensor connector. See ENGINE (COOLANT) TEMPERATURE SENSOR LOCATION table. Measure resistance across sensor connector terminals. If resistance is not as specified in the ENGINE (COOLANT) TEMPERATURE SENSOR RESISTANCE table, replace sensor.
| Application | Location | |
|---|---|---|
| NX & Sentra | ||
| 1.6L | On Intake Manifold, At Timing Chain End Of Engine | |
| 2.0L | At Front Of Engine, Above Oil Filter | |
| Temperature °F (°C) | Ohms |
|---|---|
| 68 (20) | 2100-2900 |
| 122 (50) | 680-1000 |
| 176 (80) | 300-330 |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
