Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
System Operational Check
- Turn ignition on. If ANTI-LOCK warning light on instrument cluster does not come on, go to DIAGNOSTIC PROCEDURE NO. 7. See Figure . If light comes on, start engine. If light remains on after starting engine, go to RETRIEVING CODES under DIAGNOSIS & TESTING.
- If light goes off after starting engine, drive vehicle at 19 MPH or faster for at least one minute. If light remains off, no fault has been detected by ECU. If light comes on during road test, go to RETRIEVING CODES under DIAGNOSIS & TESTING.
- If light does not come on after engine is started and a problem exists, diagnose by symptom. See SYMPTOMS under TROUBLE SHOOTING.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.