1991 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

Normal Conditions

  • Ensure battery is fully charged and maintains at least 9.6 volts during cranking.
  • Ensure fuel pressure is within specification.
  • Perform appropriate test in INJECTOR MALFUNCTION diagnostic chart in I - SYS/COMP TESTS article in the ENGINE PERFORMANCE Section. Use DIAGNOSTIC CHARTS DIRECTORY table in I - SYS/COMP TESTS article to locate chart.
  • Check for spark using spark tester.
  • Check spark plug for improper gap or fouling.
  • Check EGR control valve operation.
  • Check ECU harness connector.
  • Check ECU power source and ground circuit. See ECU POWER SOURCE & GROUND diagnostic chart in I - SYS/COMP TESTS. Use DIAGNOSTIC CHARTS DIRECTORY TABLE in I - SYS/COMP TESTS article to locate chart.
  • Try a known good ECU.
  • Check timing belt for proper installation (V6 models).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.